Design and Development of Logic Gate Trainers for the Acquisition of Specific Skills in Electronic Technology at Federal College of Education (Technical), Asaba

Citation Count

Abstract Views

24

Downloads

6

Abstract

This study reports the design, fabrication, and testing of a low-cost logic gate trainer developed to strengthen practical digital-electronics skills among students at the Federal College of Education (Technical), Asaba, Nigeria. The work addresses the gap between classroom instruction in Boolean logic and the hands-on experimentation needed for students to internalise it, a gap widened by limited institutional funding for imported scientific equipment. Using a design-and-development approach carried out in three stages: design, procurement, and fabrication/testing. The researchers produced an all-in-one trainer board comprising input logic switches, LED output indicators, a regulated power-supply unit, and a breadboard/IC socket area. Woodwork and metalwork techniques were used to construct the board and a mobile stand, circuit diagrams were prepared and printed onto the board, and components such as BC547 transistors, resistors, and diodes were soldered according to the prepared schematics. The trainer was tested against the truth tables of seven logic gates: AND, OR, NOT, NAND, NOR, XOR, and XNOR, through power connection, input configuration, and output observation. Every gate reproduced its expected truth table across all input combinations, confirming the reliability of the fabricated hardware. The findings suggest that locally sourced, low-cost trainers can substitute for imported laboratory kits in resource-constrained Technical Vocational Education and Training (TVET) settings, giving students repeated, tactile access to the cognitive, psychomotor, and affective domains of learning. The article closes with recommendations for classroom adoption and for extending the design to sequential logic circuits.

Keywords: logic gate trainer, digital electronics, TVET, instructional technology, experiential learning



Journal Title: Journal of Technical and Vocational Education and Training

Category: Electrical and Electronics Engineering

ISSN: 3141-2742

Year of Establishment: 2025

Section: Faculty of vocational and Technical Education University of Benin in collaboration with School of Technology Education, FCET, Asaba

Volume: 1

Issue: 5

Abstract Views:

Total Download: 6

John Blessing Yokk, Yinusa A. Adekola, Akinola O. Oguntunwase, Obed Okoh. 2026 Design and Development of Logic Gate Trainers for the Acquisition of Specific Skills in Electronic Technology at Federal College of Education (Technical), Asaba. Journal of Technical and Vocational Education and Training. 1 (5). 1-15. https://doi.org/10.61955/QZLBGK

Our Partners