Abstract
Sensitive equipment across Nigeria routinely receives mains voltage far outside the statutory band, with prolonged undervoltage of 150 to 200 volts interspersed with sags and swells, and commercial regulators with narrow correction windows respond by disconnecting the load much of the time. This paper presents a relay-tap automatic voltage regulator built on a low-cost eight-bit microcontroller, correcting inputs of 110 to 260 volts to 230 volts within plus or minus 7.4 percent. A geometric band design shows that six autotransformer taps are the minimum that cover the full input range at this tolerance, with closed-form relations for tap count, ratios and output bounds that rescale the plan to any specification. True root-mean-square sensing through a 155 to 1 biased divider with a 530 hertz anti-aliasing pole, three volt hysteresis and zero-crossing relay actuation give a worst-case correction latency of 59 milliseconds, under three mains cycles. A two hundred thousand sample probabilistic evaluation against a stylised Nigerian supply scenario finds the design holds the load within the 230 volt plus or minus 10 percent utilisation band for 99.0 percent of samples, against 89.0 percent for a typical commercial unit spanning 160 to 250 volts and 45.9 percent for the raw supply. Non-ideal allowances are budgeted: a 3 percent transformer regulation limit keeps the full-load output inside the band, efficiency runs 97.6 to 99.7 percent, and a bill of materials near 19000 naira positions the design between imported relay regulators and servo machines. All parameters are stated in full for exact reproduction.
Keywords: Voltage regulator, Voltage stabiliser, Microcontroller, Power quality, Wide input range, Nigeria

National Library of Nigeria
Association of Nigerian Authors
Nigerian Library Association
EagleScan
Crossref